Photo machine does not ink out how to do, photo machine nozzle does not ink out of the question is too widespread, the following Audley photo machine technology for you to sum up over the years under what circumstances do not ink out of the solution.
First, general investigation
1Maybe the machine has been put for a long time, the nozzle is dry, cleaning depends on what ink you are, water-based can be directly used to clear the blister, weak solvent will have to use cleaning liquid, after soaking with a needle to inject water or cleaning liquid into the nozzle, pay attention to the water when not too strong, it is easy to blow the nozzle, and then see whether the nozzle water situation is good. The second is to look at the ink station ink absorption situation, if the ink absorption is normal, you hit the test, see what the test strip is like, if a black then the nozzle may burn.
　　2If the foam photo machine, you first see whether the nozzle is burned, switch the nozzle that does not produce ink with the ink, see the test results, if the ink is still not out, it should be the nozzle burned, if the ink is out, then you check the contact belt, if the whole does not produce ink, check the car version,
Second, detailed investigation
1The influence of static electricity, too high static electricity will also affect the photo machine nozzle ink, the ground wire of the photo machine is not connected, static electricity can not be exported, and caused by the fault.
2When there is too much air in the ink tube or the ink tube and the nozzle leak, the nozzle will not produce ink. It is necessary to check the nozzle and ink duct, drain the leaking part and then use the ink pump to pump the nozzle.
3The solution of no ink in a single nozzle and no ink in all nozzles is different. When the single nozzle of the photo machine does not produce ink, after cross-transposition cleaning the contact, determine whether there is a problem with the contact belt. If there is no problem with the contact, it can be judged that it is burned out or the nozzle is blocked. If a fixed color often blocks the nozzle, there may be a problem with the ink itself. Contact the ink supplier.
4The photo machine small car plate is damaged, and it can be replaced with a new small car plate.
5Ink problem: the nozzle is blocked, the use of poor quality ink, the particles in the ink are too large, accumulate over time, and form a layer of impurities on the filter screen of the nozzle, so that the ink can not smoothly flow into the heating bin, resulting in the nozzle does not produce ink. Can often through the ink pump suction nozzle can be solved, if serious, need to use the syringe to absorb pure water, inject into the nozzle, and then shake the nozzle, and then use the syringe to suck out, such as repeated several times, to achieve the purpose of removing impurities.
6The amount of ink pre-added in the nozzle is not standardized, too much or too little will come out of the nozzle does not produce ink, the standard practice is pre-added20-25MLInk left and right.
7The last case: the nozzle is broken(Burn up)In this case, there is no alternative but to replace a new nozzle.
