I believe that friends who have used photo machines or inkjet printers are no strangers to the phenomenon of blockage of the nozzle?In fact, the principle of the photo machine and ordinary desktop printer principle is the same, the use of inkjet technology. However, why is the winter photo machine easy to block the nozzle, Audley photo machine manufacturers to give you an analysis of the situation!

Analysis of several common reasons will easily cause nozzle blockage:

First, the ink problem

The ink accumulates too much outside the nozzle of the photo machine, and to a certain extent, it will block the nozzle, which is more common and one of the most easy reasons for the blockage of the nozzle. Because the ink will volatilize and dry after contact with the air, after the nozzle is sprayed, there may be residual ink on the surface of the nozzle and the medium, because the ink will form solid objects after drying, especially oily ink, if not cleaned or cleaned in time, it is easy to form nozzle blockage for a long time.

Second, replace different inks

Because the composition of the ink produced by different manufacturers is different, there is no more cleaning of the nozzle and the pipe when it is replaced, so the original residual ink and the replacement ink are mixed together, and the ink dryness and other unknown chemical reactions are easy to block the nozzle.

3. Piezoelectric crystal problem

For example, piezoelectric crystal damage, the general life of the piezoelectric nozzle is about one year, according to the use of the nozzle, in this case, usually the nozzle will be completely out of ink, not blocked.

Fourth, the working environment of the photo machine

For example, the indoor temperature of the work, the temperature of the air, etc., will also easily cause the nozzle to block, so, in winter and 100 days under the same temperature conditions, we should pay more attention to the daily maintenance work of the photo machine.Usually in this case, we recommend that the working room temperature of the photo machine is15Go to30Between degrees, not too high or too low, the relative temperature is40%to70%Around.

5. Other relevant factors

Such as too much dust in the working environment of the photo machine or oil on the machine, it is easy to adhere to the nozzle or ink, forming debris to block the nozzle.

The above points are often encountered in the day caused by the blockage of the nozzle,Therefore, we should do a good job in the maintenance of the daily photo machine nozzle according to the above reasons. In this way, not only can you make your photo machine work easier, but also can greatly extend the service life of the nozzle, to the company or store to bring greater benefits.